One of the best features of the Kaweco Sport is that you can easily and quickly turn it into an eyedropper - enabling you to hold a ton of ink, and if you're using the clear demonstrator, have a moving air bubble in a tube of ink to keep you entertained during long meetings. Kaweco takes international short cartridges and has its own brand of cartridges, each holding around 0.5 mL. A eyedropper Kaweco can hold about 2 mL. You will need: Kaweco Sport Pen 100% Pure Silicone Grease Syringe or Eyedropper Bottle of Ink  Image The silicone grease is to prevent any leaks. You can buy silicone grease at some plumbing or hardware stores, other pen supply stores, and most (if not all?) diving/scuba stores. We went to Home Depot, and only found some "plumber's grease" which appeared to be at least mostly silicone grease, but we weren't sure if it was 100% pure - which is the safest to guard against any ink reactions. You can also purchase from us here. One jar or tube of silicone grease will last you quite a while. The syringe, for getting ink from the bottle to the pen, you can get from a pharmacy. We offer blunt tip, reusable needles here. In this post, we're converting a Kaweco Sport Demonstrator Fountain Pen, but you can also do this with a Preppy, or find tips here for your Serwex 101, which is already an eyedropper. You should not turn your Kaweco Al-Sport into an eyedropper, since it's made out of aluminum, which can react with the ink. The ink we're using is Noodler's Tiananmen Square. Image Image Image The silicone grease should be applied to the threads of the nib section. You don't need a huge amount, but make sure you cover the threads evenly so ink can't leak out. Image Image Image Image After you've filled up the barrel, you can twist in the nib section. Be careful to keep the pen barrel up so you don't spill! Wipe off any excess silicone grease that squeezed through the threads. You are good to go! Turn it nib down so the ink can begin to make its way through the feed. Image For the most part, while eyedroppers are more prone to leaks than, for example, cartridge/converter pens, you shouldn't get a leak if you have sealed it properly and aren't doing crazy things with it. Some eyedroppers can tend to "blob" out ink from the nib when the barrel is almost empty, due to changes in the air pressure and the capillary action of the feed. As well, when you have a lot of air in the barrel (2/3 air, 1/3 ink), and you warm up the barrel too much with your hands or in a shirt pocket, you might also start to get blobs. The increase in pressure due to the warming of the air can force droplets of ink out.  If you're someone who grips the pen tightly or for long periods of time, warming up the air in the barrel, you may also want to considering making sure your pen is refilled with ink when it nears the halfway point. Each time you unscrew and screw the section and barrel to refill the ink, you may squeeze out a bit of the silicone grease, so I would recommend refreshing the silicone grease every once in a while, especially if you're cleaning out the pen to change ink colours. Image

Comments

Alex

Alex said:

This eyedropper and silicone grease is all new to me. Just wondering if anyone has tried using Teflon tape, the type plumbers use to wrap around threads, to prevent the ink from leaking out. It would take just one complete turn of the tape around the thread to make a leak proof seal.. Just wondering.

Stevdyep

Stevdyep said:

Buy Female Viagra In India Safegenericpills [url=http://sildenaf75mg.com]viagra[/url] Find Finasteride Legally Tablet Acheter Vrai Propecia

Stevdyep

Stevdyep said:

Amoxicillin Osage For 7 Month Old Darifenacin [url=http://rxbill6.com]india 4 pharmacy levitra cheap[/url] Cialis De Farmacia Cialis 20 Pharmacie En Ligne Con Prezzi Kamagra Prescrizione

RD

RD said:

I just used the syringe/needle attachment to fill the empty preppy cartridge with ink, thereby bypassing the grease etc. worked like a charm.

wonderpens

wonderpens said:

I’ve had several eyedroppered Preppies without an o-ring, including a few in the shop, without a problem. I think the o-ring also serves to prevent over-tightening, which can crack the plastic leading to leaking or worse.

John

John said:

Where would one buy an o-ring? thanks.

Mags

Mags said:

Most of the instructions I’ve seen for converting a Platinum Preppy to eyedropper involve an o-ring in addition to the silicone grease, do you think that is necessary or is greasing the threads typically enough?

Liz

Liz said:

Thanks for reading!

Unfortunately, there isn’t a way (that I know of) to clean this! This has happened on my own clear Sport as well, and I assume the other sports, but you just can’t see it. I’m sorry that it’s just bad news here!

The Kaweco Sport and Al Sport | Wonder Pens

The Kaweco Sport and Al Sport | Wonder Pens said:

[…] people who pick the Sport: – like the price – want to convert it to an eyedropper – specifically want a demonstrator or other […]

How to Use Your Kaweco Squeeze Converter | Wonder Pens

How to Use Your Kaweco Squeeze Converter | Wonder Pens said:

[…] If all else fails, you can always live life on the edge. […]

Mark

Mark said:

Very nice review. I have converted my Kaweco Sport to an eyedropper. I was going to change ink when I noticed that there is ink getting between the outer clear barrel and the black inner piece in the section. Is there a way to clean this out? How if possible can I prevent this? I can’t seem to remove this piece to clean. It probably shouldn’t bother me but it does. Thanks!

Leave a comment